Nowadays more and more families choose to decorate with wallpaper, wallpaper decoration effect is good, but improper construction is also easy to leave regret, especially in the moisture-proof crack prevention problem should pay attention.
Put some waterproof paint on the wall before wallpapering, and then put full of scraping putty with waterproof paint, then paste the wallpaper according to standard craft, generally not easy to damp off. For antifouling and anti-cracking, it is common to clean the wall with a damp cloth before applying it, and apply glue on both the wall and the back of the wallpaper to enhance the adhesion of the wallpaper to the wall. In particular, increase the amount of glue on the seams of the wallpaper, and then use a clean cloth to press and smooth it.
Wallpaper Tips: How to Uncover Wallpaper
Use a left hand to fold a piece of wet cloth tightly against the edge of the wallpaper. The right hand takes a hot iron and presses it on a wet cloth so that the moisture on the cloth penetrates the wallpaper and the wallpaper can be easily peeled off.
Wallpaper Tips: How to Paste Wallpaper
First grind the wall surface with sandpaper, evenly brush the water on the back of the cut wallpaper, or soak it in the bathtub for a period of time to fully expand the wallpaper, then use special glue for the commercially available wallpaper, or add 50% water with 107 glue. The formulated adhesive is thinly brushed and set aside. Then a thin layer of glue is applied to the wall and carefully tiled. Care must be taken to ensure that the position of the pattern is coordinated and that it is flattened with a damp cloth. If there are bubbles in the wallpaper, you can use a thick needle to wear a small hole in the center of the bubble, and then squeeze out the air and then smooth it to eliminate bubbles. Begin to paste from the unobtrusive corner behind the door. Paste one by one, and cut off the excess wallpaper at the top and bottom.
Wallpaper Tips: How to identify the construction quality of wallpaper
1 Before the construction, the equipment or accessories protruding from the surface of the base layer shall be removed. The nail cap shall enter the surface of the base layer and be coated with rust-proof paint. The nail holes shall be filled with oily putty. The putty on the base should be firm and firm, and should not be powdered, wrinkled, or cracked. 2 The grass-roots surface should be flat, dry, and seamless, and the recessed position of the convex wall cannot be seen with the naked eye. 3 paste firmly, the same color surface. There must be no air bubbles, empty drums, sand, cracks, curls, wrinkles, spots, and glue marks. There must be no defects such as missing stickers, subsidies, and delamination. 4 The pattern and pattern of the patchwork joints should be consistent, the lap should be smooth, and there should be no visible patchwork at 1.5 meters from the wall surface. 5 The wallpaper is connected tightly with the decoration line, the skirting board, and the wainscot. The gap is seamless, and the yin and yang angles are vertical.
Entrance decoration restaurant decoration decoration paint home decoration
Our LED Emergency Twin Spot Lights are a cost effective replacement for old fashioned halogen emergency twin spot fittings. Due to the low power consumption of the LED lamps, only one battery is required, reducing option during charging. The super bright adjustable heads make this twin spot ideal for commercial and industrial applications. with a self test feature every 90 days to ensure correct operation. The Led Emergency Lights design makes it quick and simple to install.
Twin Spot Emergency Light,Emergency Twin Spot,Led Twin Spot Emergency Lights,Led Emergency Twin Spot Light
Foshan Nai An Lighting Electric Co.,ltd , https://www.naipslighting.com